Overview
Accurate WAN interface configuration is essential for NetOp to calculate throughput utilization correctly. Without bandwidth limits defined, throughput is displayed in statistics only — no anomalies or alerts will fire based on utilization.
Where to Configure
- Open Dashboard → Customers Table
- Select a customer
- Go to Settings → Network Interfaces
The table shows all discovered interfaces across all sites: site name, device name, IP address, interface name, speed, role, and monitoring status.
Setting Bandwidth Limits
For each ISP-facing WAN interface:
- Click the edit icon on the interface row
- Set Limit In — inbound bandwidth from ISP (in Mbps)
- Set Limit Out — outbound bandwidth to ISP (in Mbps)
- Ensure Role is set to ISP
- Save
NetOp uses these values to calculate utilization percentage and trigger throughput anomalies.
Interface Roles
| Role | Description |
|---|---|
| ISP | WAN-facing interface toward the Internet Service Provider |
| INTERCONNECT | Internal trunk or uplink between devices |
| USER | End-user or client-facing port |
Switch Port Configuration
For LAN switch ports:
- Client ports: Mark as USER. Interface-down events on client ports will not generate alerts — prevents noise from endpoint disconnects.
- Critical ports (trunk/uplink): Mark as INTERCONNECT. These are continuously monitored; port-down events generate High or Critical anomalies.
Throughput Thresholds
From Settings → Anomalies → Traffic, configure:
- Uplink utilization threshold (e.g., alert at 70%)
- Downlink utilization threshold (e.g., alert at 80%)
- Severity: High or Critical
These are percentage-based and depend on the bandwidth limits you configured above.
Common Issues
Throughput shows in statistics but no anomalies fire → Bandwidth limits (Limit In / Limit Out) are not configured for the interface.
Too many interface-down alerts → Mark end-user switch ports as USER role to suppress client disconnect noise.
Wrong site assignment for an interface → Use Settings → Site Management to reassign the device to the correct site.
Best Practices
- Configure bandwidth limits immediately after onboarding each integration.
- Use the INTERCONNECT role for all uplinks between switches and firewalls.
- Document bandwidth limits in your network inventory and keep NetOp in sync after ISP upgrades.
Comments
0 comments
Please sign in to leave a comment.